REPLACMENT INSTRUCTIONS
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP015 10/6/2010
BODY (E)
SLEEVE (D)
FACE SEAL (A)
O-RING (B)
REMOVE
SLEEVE INSTALL
WITH SLIGHT TWIST
FACE SEAL (A)
SLEEVE (D)
SLEEVE
FITTING (E)
RET. RING (F)
BODY (G)
BACK-UP RING (C)
O-RING (B)
SLEEVE
O-RING (H)
BACK-UP RING (I)
RET. RING (F)
SLEEVE INSTALL
WITH SLIGHT TWIST
FINISHED
ASSEMBLY
FINISHED
ASSEMBLY
BACK-UP RING (C)
FACE SEAL
Male Plug and Male Extended Connector Seal Replacement:
1. Remove face seal (A) from connector using a sharp tool and save. Face seals sold separately.
2. Remove sleeve (D) to expose o-ring (B) and back-up ring (C). Remove and discard old
o-ring and back-up ring.
3. Make sure body (E) and sleeve (D) are clean and free of dust and dirt before reassembling new
components to the connector.
4. Install new back-up ring (C) as shown.
5. Lubricate new o-ring (B) with petroleum jelly and install as shown.
6. Replace sleeve (D) and use a slight twisting motion to ensure that the seals remain in the ring groove.
7. Install face seal (A).
Male Swivel Connector Seal Replacement:
1. Remove face seal (A) from connector using a sharp tool and save. Face seals sold separately.
2. Remove sleeve (D) to expose o-ring (B) and back-up ring (C). Remove and discard old
o-ring and back-up ring.
3. Make sure body and sleeve are clean and free of dust and dirt before reassembling new components to
the connector.
4. Install new back-up ring (C) as shown.
5. Lubricate new o-ring (B) with petroleum jelly
and install as shown.
6. Replace sleeve (D) and use a slight twisting motion to ensure that the seals remain in the ring groove.
7. Install face seal (A).
8. Remove ret. ring (F) and discard. (This can be difficult; a sharp, stiff, bent tip pick is required).
9. Remove fitting (E).
10. Remove and replace back-up ring (I).
11. Remove and replace o-ring (H), lube new o-ring.
12. Install fitting (E). Use a slight twisting motion to ensure that the seals remain in the ring groove.
13. Install the retaining ring, making sure it is
completely seated in its groove.
Comments to this Manuals